The Elegoo H1 HT filament dryer heats up to 85°C to pull moisture out of PLA, PETG, and stubborn filaments like PA and PC before they ruin a print.
- Even, All-Around Drying: The spool turns automatically inside the chamber, so heat and moisture reach every wrap, not just the surface.
- Active Dehumidification: Two vents release humid air while drying, then seal shut so filament stays dry until your next print.
- Built for Flexible Filaments: A separate bypass outlet feeds TPU and fiber-reinforced filament smoothly, without the kinks common to a standard tube.
- Simple Touchscreen Control: The 3.5-inch touchscreen shows drying status at a glance, with 11 presets plus custom settings.
- Safety Built In: Overheat protection, a flame-resistant shell, and fault alerts keep drying safe with no need to watch over it.
Dry your filament with the H1 HT, and every print comes out smooth, strong, and free of stringing or warping.